Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: How to read the waveforms
You can sort of do that right now by enabling "Show TX in Waterfall". It is in Settings>Radio Setup>Transmit. After transmitting you can grab the vertical time scale on the right side…1 -
Re: Looking for Amplifier for working with my Flex 6300: suggestions are welcome!
Just to be clear, as Jim said due to the 4:1 ratio between AM PEP and carrier power, the unmodulated max key down for the KPA500 in AM might be about 125 watts. In AM you'd still be getting 500 …1 -
Re: Low Power Output? 6300 or 6500
I just re-tested my 6300 with 12 inch long 10 gauge DC power cables, and RF out going only through the LP-100A wattmeter then into a 50 ohm dummy load. I tested each band at 5 sec, 30 sec and 60 sec.…1 -
Re: Can SSDR utilize more than 4 processors in the Intel I7 CPU?
W4UK: "Anybody else have more than 4 in an I7? Would SSDR/Ham programs utilize the extras?" As already explained, you're likely just seeing the hyperthreaded cores on an i7. It is prob…1 -
Re: Have Other User Intefaces Been Considered ?
Technically the LM was not programmed with toggle switches -- its program was hard-wired into core memory. However certain trajectory variables involving subtle forces (light pressure, etc) could not…1
